To the question about the influence of the stresses in the elements of the reinforcement shafts at the rate of corrosion

Authors

  • V. V. Kovalenko Novosibirsk state University, Russian Federation, Russian Federation
  • I. V. Kupenko Donetsk national technical University, Ukraine
  • O. Yu. Prokopov South-Russian state Polytechnic University, Russian Federation, Russian Federation
  • S. V. Karhapolov Woodworking Tool Equipment Service, Donetsk, Ukraine

DOI:

https://doi.org/10.15802/stp2008/16297

Keywords:

stresses, elements of the reinforcement, rate of corrosion

Abstract

On the basis of laboratory explorations the features of conducting the corrosive process in the shaft reinforcement parts under the load from lifting buckets and rock mass were determined.

Author Biographies

V. V. Kovalenko, Novosibirsk state University, Russian Federation

V. V. Kovalenko

I. V. Kupenko, Donetsk national technical University

I. V. Kupenko

O. Yu. Prokopov, South-Russian state Polytechnic University, Russian Federation

O. Yu. Prokopov

S. V. Karhapolov, Woodworking Tool Equipment Service, Donetsk

S. V. Karhapolov

Published

2008-04-25

How to Cite

Kovalenko, V. V., Kupenko, I. V., Prokopov, O. Y., & Karhapolov, S. V. (2008). To the question about the influence of the stresses in the elements of the reinforcement shafts at the rate of corrosion. Science and Transport Progress, (21), 125–127. https://doi.org/10.15802/stp2008/16297

Issue

Section

TRANSPORT CONSTRUCTION